NVM OTP in GF (180nm, 130nm, 65nm, 55nm, 40nm, 28nm, 22nm, 12nm)
Predicting PLL reference spur levels due to leakage current
Michel Azarian, Sr. Applications Engineer, and Will Ezell, Mixed Signal Products, Linear Technology
EETimes (11/9/2012 12:22 PM EST)
A simple model can be used to accurately predict the level of reference spurs due to charge pump and/or op-amp leakage current in a phased-locked loop system. Knowing how to predict these levels helps pick loop parameters wisely during the early stages of a PLL system design.
Quick review of PLLs
The phase-locked loop (PLL) is a negative feedback system that locks the phase and frequency of a higher frequency device (usually a voltage controlled oscillator (VCO) whose phase and frequency are not very stable over temperature and time to a more stable and lower frequency device (usually a temperature compensated or oven-controlled crystal oscillator, (TCXO or OCXO). As a black box, the PLL can be viewed as a frequency multiplier.
|
|
E-mail This Article |
|
Printer-Friendly Page |
Related Articles
- Specifying a PLL Part 1: Calculating PLL Clock Spur Requirements from ADC or DAC SFDR
- Keeping leakage current under control
- Analysis and Summary on Clock Generator Circuits and PLL Design
- Bandgap Reference (BGR) Circuit Design and Transient Analysis in 90nm VLSI Technology
- Achieving Your Low Power Goals with Synopsys Ultra Low Leakage IO






