English
Lattice Launches Ultra Low Cost Programmable Power Management Solution for High Volume Consumer Applications
Ideally Suited for Handheld Systems Requiring Very Low Standby Power
HILLSBORO, OR – SEPTEMBER 25, 2006 – Lattice Semiconductor Corporation (NASDAQ: LSCC) today announced the addition of the programmable, ultra low cost ispPAC®-POWR607 device to its second generation Power Manager II product family. The new devices achieve a sub- $1.00 price point in high volume, targeting many cost-sensitive power management applications in consumer markets such as LCD TV, automotive multimedia systems, GPS receivers, Multimedia Terminal Adapters and set-top boxes. The ispPAC-POWR607 device integrates a complete set of power management functions that typically require multiple ICs.
“The POWR607 device provides ideal support for any 16-bit or 32-bit microprocessor-based system,” said Stan Kopec, Lattice corporate vice president of marketing. “Designers traditionally have used a design-specific set of discrete off-the-shelf devices to generate the CPU Reset, Power Supply Fault Interrupts and Watchdog Timers for each microprocessor-based design. The POWR607 device can implement all these functions through logic programmed into its on-chip CPLD, which results in a standardized, lower cost design solution.
“The Power Manager II devices are programmable logic devices plus analog peripheral circuitry optimized for power management functions,” said Kopec. “Because these devices are software programmable, each of the five family devices can replace any combination of supervisory devices, reset generator devices, hot-swap controllers, power supply sequencers and power supply trimming and margining circuits, as well as multiple resistors and capacitors. Consequently, a Power Manager II device reduces both the bill-of-material cost and the time to market.”
Architecture
The POWR607 device uses Lattice’s award winning Power Manager architecture. The device can monitor up to 6 circuit board power supplies and generate signals such as a CPU Reset, including pulse stretching and power supply fault interrupt, using the on-chip 16 macrocell CPLD, four programmable timers and 7 outputs (two of which also can be configured as high voltage MOSFET drivers). The POWR607 device can be powered down using an external logic signal, or by an internally generated signal. Once in the power down state, the device draws a mere 10 microamperes from the power supply. The POWR607 devices are packaged in space-saving 5mm x 5mm QFN packages.
Applications
Due to its low cost, very small footprint and low power standby feature, the ispPAC-POWR607 is an ideal power management solution in handheld consumer, telecom and industrial applications.
All Power Manager devices, including the POWR1220AT8, POWR1014/A, POWR6AT6 and POWR607, provide a standard, off-the-shelf programmable mixed-signal solution for power management across multiple circuit boards. This solution improves reliability, speeds time-to-market and reduces cost.
Software Support
Designs for the ispPAC-POWR607 are implemented using the Windows-based Lattice PAC-Designer® Software version 4.7.
PAC-Designer 4.7 software is available for download free of charge from the Lattice website, www.latticesemi.com
Pricing and Availability
In high volume (100KU+) the price of the ispPAC- POWR607 devices in the 32-pin QFN package and industrial temperature range is $0.95. Samples are available now.
About Lattice Semiconductor
Lattice Semiconductor Corporation provides the industry’s broadest range of Programmable Logic Devices (PLD), including Field Programmable Gate Arrays (FPGA), Complex Programmable Logic Devices (CPLD), Programmable Mixed-Signal Products (ispPAC®) and Programmable Digital Interconnect Devices (ispGDX®). Lattice also offers industry leading SERDES products.
Lattice continues to deliver “More of the Best” to its customers with comprehensive solutions for system design, including an unequaled portfolio of high performance, non-volatile and low cost FPGAs.
Lattice products are sold worldwide through an extensive network of independent sales representatives and distributors, primarily to OEM customers in communications, computing, industrial, consumer, automotive, medical and military end markets. For more information, visit http://www.latticesemi.com
HILLSBORO, OR – SEPTEMBER 25, 2006 – Lattice Semiconductor Corporation (NASDAQ: LSCC) today announced the addition of the programmable, ultra low cost ispPAC®-POWR607 device to its second generation Power Manager II product family. The new devices achieve a sub- $1.00 price point in high volume, targeting many cost-sensitive power management applications in consumer markets such as LCD TV, automotive multimedia systems, GPS receivers, Multimedia Terminal Adapters and set-top boxes. The ispPAC-POWR607 device integrates a complete set of power management functions that typically require multiple ICs.
“The POWR607 device provides ideal support for any 16-bit or 32-bit microprocessor-based system,” said Stan Kopec, Lattice corporate vice president of marketing. “Designers traditionally have used a design-specific set of discrete off-the-shelf devices to generate the CPU Reset, Power Supply Fault Interrupts and Watchdog Timers for each microprocessor-based design. The POWR607 device can implement all these functions through logic programmed into its on-chip CPLD, which results in a standardized, lower cost design solution.
“The Power Manager II devices are programmable logic devices plus analog peripheral circuitry optimized for power management functions,” said Kopec. “Because these devices are software programmable, each of the five family devices can replace any combination of supervisory devices, reset generator devices, hot-swap controllers, power supply sequencers and power supply trimming and margining circuits, as well as multiple resistors and capacitors. Consequently, a Power Manager II device reduces both the bill-of-material cost and the time to market.”
Architecture
The POWR607 device uses Lattice’s award winning Power Manager architecture. The device can monitor up to 6 circuit board power supplies and generate signals such as a CPU Reset, including pulse stretching and power supply fault interrupt, using the on-chip 16 macrocell CPLD, four programmable timers and 7 outputs (two of which also can be configured as high voltage MOSFET drivers). The POWR607 device can be powered down using an external logic signal, or by an internally generated signal. Once in the power down state, the device draws a mere 10 microamperes from the power supply. The POWR607 devices are packaged in space-saving 5mm x 5mm QFN packages.
Applications
Due to its low cost, very small footprint and low power standby feature, the ispPAC-POWR607 is an ideal power management solution in handheld consumer, telecom and industrial applications.
All Power Manager devices, including the POWR1220AT8, POWR1014/A, POWR6AT6 and POWR607, provide a standard, off-the-shelf programmable mixed-signal solution for power management across multiple circuit boards. This solution improves reliability, speeds time-to-market and reduces cost.
Software Support
Designs for the ispPAC-POWR607 are implemented using the Windows-based Lattice PAC-Designer® Software version 4.7.
PAC-Designer 4.7 software is available for download free of charge from the Lattice website, www.latticesemi.com
Pricing and Availability
In high volume (100KU+) the price of the ispPAC- POWR607 devices in the 32-pin QFN package and industrial temperature range is $0.95. Samples are available now.
About Lattice Semiconductor
Lattice Semiconductor Corporation provides the industry’s broadest range of Programmable Logic Devices (PLD), including Field Programmable Gate Arrays (FPGA), Complex Programmable Logic Devices (CPLD), Programmable Mixed-Signal Products (ispPAC®) and Programmable Digital Interconnect Devices (ispGDX®). Lattice also offers industry leading SERDES products.
Lattice continues to deliver “More of the Best” to its customers with comprehensive solutions for system design, including an unequaled portfolio of high performance, non-volatile and low cost FPGAs.
Lattice products are sold worldwide through an extensive network of independent sales representatives and distributors, primarily to OEM customers in communications, computing, industrial, consumer, automotive, medical and military end markets. For more information, visit http://www.latticesemi.com
|
||||||
Related News
- Lattice FPGAs with High I/O Density Bring Low Power Signal Bridging and Interface Management to Edge Devices
- Lattice Announces New CPLD Family For Low Power, High Volume Portable Applications
- CEVA Unveils New Family of Multimedia Solutions for High Volume, Low Cost Mobile Consumer Electronics
- Key ASIC Launches ASIC & SoC Design-to-Manufacture Services for Communications and Consumer Electronics Applications; Company Specializes in High Performance, Low Power Mixed-Signal and Digital Design
- AMD and Samsung Announce Strategic Partnership in Ultra Low Power, High Performance Graphics Technologies
Most Popular
- RISC-V International Promotes Andrea Gallo to CEO
- See the 2025 Best Edge AI Processor IP at the Embedded Vision Summit
- Andes Technology Showcases RISC-V AI Leadership at RISC-V Summit Europe 2025
- Ceva, Inc. Announces First Quarter 2025 Financial Results
- Cadence Unveils Millennium M2000 Supercomputer with NVIDIA Blackwell Systems to Transform AI-Driven Silicon, Systems and Drug Design
|
E-mail This Article | 
|
|
Printer-Friendly Page |